Skip to content
GTECH Calibration
Portal

P1197

Mileage Switch Circuit.

  • Mazda
  • Powertrain
  • Manufacturer code
  • Low severity

How this code is built

P
SystemPowertrain
1
Defined byThe manufacturer
1
AreaFuel and air metering
97
FaultThe specific fault in that area

What it means

On Mazda, P1197 is defined as a fault in the Mileage Switch Circuit. The engine control unit monitors this circuit and sets the code when the signal is outside the expected range or does not match what it expects. Its exact function and location depend on the model and year, so check the manufacturer's information for the specific vehicle before replacing anything.

Symptoms

  • Engine warning light on
  • Service or maintenance reminder light behaving oddly, on some models
  • Usually no change in driveability
  • Fault may return soon after the code is cleared
  • Possible stored related codes in the same circuit

Possible causes

  • Damaged, chafed or broken wiring in the mileage switch circuitlikely
  • Corroded, loose or pushed-out pins at the switch or control unit connectorlikely
  • Faulty mileage switch or the unit it is part ofpossible
  • Short to earth, short to supply or open circuit in the signal or reference leadpossible
  • Poor earth or low supply voltage to the circuitpossible
  • Fault inside the engine control unitrare

How to diagnose

  1. Read all stored codes and freeze frame data, and note whether P1197 is current or stored.
  2. Look up the model-specific description and wiring diagram for the mileage switch circuit, as its location and function vary.
  3. Inspect the switch, wiring and connectors for damage, moisture, corrosion, heat damage or rubbing.
  4. Check the battery condition and charging voltage, as low voltage can cause false circuit faults.
  5. Check the supply, signal and earth at the switch connector with a multimeter against the specification.
  6. Test the wiring between the switch and control unit for continuity, and for shorts to earth or supply.
  7. Test the switch itself against the manufacturer's specification.
  8. Clear the code, road test and recheck to confirm the fault has been fixed.

How to fix

  • Repair or replace damaged wiring and secure it away from sharp edges or heat.
  • Clean, repair or replace faulty connectors and terminals.
  • Replace the mileage switch if it fails testing.
  • Restore good earth and supply connections, and correct any battery or charging faults.
  • Replace or have the engine control unit checked only after wiring and switch faults are ruled out.

Can I keep driving?

Low severity

The car can normally be driven as the fault does not usually affect running. Book it in for diagnosis soon, since the warning light may hide other faults appearing.

Guide written by AI from the code's definition. Confirm with a diagnosis before replacing parts.

This code for other makes

Nearby codes